Phone: +49 7024 – 9614 – 0
Fax: +49 7024 – 9614 – 106
Is your compressed air system still tight?
Analyses confirm that there are leaks in all compressed air stations and enormous quantities of compressed air in which you have invested expensive electrical energy are getting lost on the way from the air compressor to the compressed air consumer.
A large number of firms from a variety of industrial sectors have been analysed in the course of the measuring campaign.
The average leakage rate was approximately 25%; the proud “winner” had a leakage rate of around 80%. In other words: of 100 kWh this company was blowing 80kWh back into the atmosphere to no avail whatsoever.
Leaky spots in an overall compressed air system, i.e. in the distributor line or at the various connection points to the consumers represent a high cost factor. The leaky spots act like jets through which the air is expelled at an enormous speed. In view of the fact that air is invisible and odourless and does not represent a direct hazard, it is usually not treated with a similar degree of attention as, for example, a leak in a water pipe.The increasing volumetric flow rate requirement caused by the leaks gives rise to higher energy costs for the generation of compressed air.
The following table gives an impression of the extent of energy costs caused by leakage.
As you can see, even a small leakage with a diameter of only 5 mm (total diameter of the whole of many small leaks adding up to 5 mm) in a 12-bar compressed air network has disastrous consequences, i.e. air losses of 58.5 L/s for the generation of which you have to pay over 16,000 € p.a.
The first step towards optimisation, i.e. energy saving, is to establish the quantity leaking out.
The quantity leaking out of a compressed air system can be established approximately by emptying the pressure tank. This involves measuring, for example, the period during which the pressure drops by 1 bar. During measuring the tank is no longer supplied with compressed air. Assuming that the compressed air flows out isothermally, the quantity leaking out of a compressed air system can be approximately determined by applying the following formula.
The second method for roughly determining the quantity of leakage is via the duty cycle of the compressor. This method can be applied to compressors with intermittent and no-load operation only.
The consumers in the network are switched off. Owing to leaks in the system compressed air is consumed and the network pressure drops. The compressor has to replace the quantity leaking out.
Over a measuring period the total running time T of the compressor is measured. To obtain a representative result, the measuring period t should include several switching intervals of the compressor.
Another method for determining the quantity of leakage is to measure by means of volumetric flow measuring devices (so-called data loggers), which calculate the compressed air consumption profiles of a compressed air station via the load cycles of the compressor. The existing leaks can be deduced from these measuring data / graphs.
Accurate determination: we would be pleased to measure your compressed air consumption (measuring period approx. 7 days), because “It is better to know than to assume”.
As you can see, in many cases establishing
is easy and remedying it relatively cheap, particularly in view of the fact that approx. 70% of compressed air leaks occur in the last 30% of the compressed air system.
Especially weak spots are: